Search results for "natural filler"

Natural Compounds as Sustainable Additives for Biopolymers

2020

In the last few decades, the interest towards natural compounds, coming from a natural source and biodegradable, for biopolymers is always increasing because of a public request for the formulation of safe, eco-friendly, and sustainable materials. The main classes of natural compounds for biopolymers are: (i) naturally occurring fillers (nFil), such as nano-/micro- sized layered alumino-silicate: halloysite, bentonite, montmorillonite, hydroxyapatite, calcium carbonate, etc.; (ii) naturally occurring fibers (nFib), such as wood and vegetable fibers; (iii) naturally occurring antioxidant molecules (nAO), such as phenols, polyphenols, vitamins, and carotenoids. However, in this short review, …

VALORIZATION OF ANCHOVY FISHBONE WASTES FOR THE PREPARATION OF BIOPOLYMERIC BASED GREEN COMPOSITES FOR FOOD PACKAGING APPLICATIONS

Green Composites Based on Hedysarum coronarium with Outstanding FDM Printability and Mechanical Performance

2022

The addition of natural scraps to biodegradable polymers has gained particular interest in recent years, allowing reducing environmental pollution related to traditional plastic. In this work, new composites were fabricated by adding 10% or 20% of Hedysarum coronarium (HC) flour to Poly (lactic acid) (PLA). The two formulations were first produced by twin screw extrusion and the obtained filaments were then employed for the fabrication of composites, either for compression molding (CM) or by fused deposition modeling (FDM), and characterized from a morphological and mechanical point of view. Through FDM it was possible to achieve dense structures with good wettability of the filler that, on…

Hedysarum coronarium-Based Green Composites Prepared by Compression Molding and Fused Deposition Modeling

2022

In this work, an innovative green composite was produced by adding Hedysarum coronarium (HC) flour to a starch-based biodegradable polymer (Mater-Bi®, MB). The flour was obtained by grinding together stems, leaves and flowers and subsequently sieving it, selecting a fraction from 75 μm to 300 μm. Four formulations have been produced by compression molding (CM) and fused deposition modeling (FDM) by adding 5%, 10%, 15% and 20% of HC to MB. The influence of filler content on the processability was tested, and rheological, morphological and mechanical properties of composites were also assessed. Through CM, it was possible to obtain easily homogeneous samples with all filler amounts.…